Omron NX Series User Manual

Relevant Manuals
The following table provides the relevant manuals for the NX-series CPU Units. Read all of the man-
uals that are relevant to your system configuration and application before you use the NX-series CPU
Unit.
Most operations are performed from the Sysmac Studio Automation Software. Refer to the Sysmac
Studio Version 1 Operation Manual (Cat. No. W504) for information on the Sysmac Studio.
Purpose of use
Manual
Basic informa-
tion
NX-series NX502 CPU Unit Hardware User’s Manual NJ/NX-series CPU Unit Software User’
s Manual
NJ/NX-series Instructions Reference Manual NJ/NX-series CPU Unit Motion Control User's Manual NJ/NX-series Motion Control Instructions Reference Manual NJ/NX-series CPU Unit Built-in EtherCA
T Port User´s Manual
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual NX-series EtherNet/IP Unit User
’
s Manual
NJ/NX-series CPU Unit OPC UA User's Manual NX-series CPU Unit FINS Function User
’
s Manual
NJ/NX-series Database Connection CPU Units User’
s Manual
NJ/NX-series Troubleshooting Manual
Introduction to NX502 CPU Units
l
Setting devices and hardware
l
Using motion control
l
Using EtherCAT
l
Using EtherNet/IP
l l
Software settings
l
Using motion control
l
Using EtherCAT
l
Using EtherNet/IP
l l
Using OPC UA
l
Using FINS
l
Using the database connection service
l
Writing the user program
l l
Using motion control
l l
Using EtherCAT
l
Using EtherNet/IP
l l
Using OPC UA
l
Using FINS
l
Using the database connection service
l
Programming error processing
l
Relevant Manuals
2
NX-series EtherNet/IP Unit User's Manual (W627)

Omron NX Series Specifications

General

Brand	Omron
Model	NX Series
Category	Controller
Language	English