Omron NX Series - Support Software

1-4
Support Software
The followings are the Support Software for using the NX-series EtherNet/IP Unit.
l
Sysmac Studio
This software is used to configure all functions of the NX-series EtherNet/IP Unit.
The NX-series EtherNet/IP Unit is supported by version 1.54 or higher.
Refer to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504) for details on the Sysmac
Studio.
l
Network Configurator
This software is used to configure tag data links.
The NX-series EtherNet/IP Unit is supported by version 3.74 or higher.
For the details on the settings, refer to Section 9 Tag Data Link Functions on page 9-1.
1 Features and System Configuration
1-14
NX-series EtherNet/IP Unit User's Manual (W627)