Omron NX Series User Manual

• Differences Found in the Device Type
Click the OK Button or the
Close Button.
5 If multiple nodes have been selected and compared, the following message is displayed. Click
the Yes
Button.
The comparison results are displayed in order of the selected nodes.
9-2-12
Starting and Stopping Tag Data Links
This section describes the procedure for starting/stopping tag data links. For details on how to connect
Network Configurator to a network, refer to 9-2-8 Connecting the Network Configurator to the Network
on page
9-48.
Automatically Starting Tag Data Links
Tag data links are automatically started immediately after the data link parameters are downloaded
from the Network Configurator.
9 Tag Data Link Functions
9-61
NX-series EtherNet/IP Unit User's Manual (W627)
9-2 Setting Tag Data Links
9
9-2-12 Starting and Stopping Tag Data Links

Omron NX Series Specifications

General

Brand	Omron
Model	NX Series
Category	Controller
Language	English