Omron NX Series User Manual

Event name SNMP Settings Changed Event code 96510000 hex
Meaning The SNMP settings were changed.
Source X Bus Ethernet Function Module Source details 1 to 4: Mounting
position of the X
Bus Unit (unit
number)
and
SNMP
are given
in combination
Detection tim-
ing
When down-
loaded
Error attributes Level Information Recovery --- Log category System
Effects User program Continues. Operation Not affected.
Indicators Ethernet NET RUN Ethernet NET ERR Ethernet LINK/ACT
--- --- ---
Device variable Variable Data type Name
None --- ---
Cause and cor-
rection
Assumed cause Correction Prevention
The SNMP settings were changed. --- ---
Attached infor-
mation
Attached information 1: Changes in SNMP Service
• 1: SNMP service enabled
• 2: SNMP service disabled
• 3: SNMP service settings changed
• 4: No change (Not 1, 2, or 3)
Attached information 2: Changes in Recognition 1
• 1: Recognition 1 enabled
• 2: Recognition 1 disabled
• 3: Recognition 1 settings changed
• 4: No change (Not 1, 2, or 3)
Attached information 3: Changes in Recognition 2
• 1: Recognition 2 enabled
• 2: Recognition 2 disabled
• 3: Recognition 2 settings changed
• 4: No change (Not 1, 2, or 3)
Precautions/
Remarks
None
14 Troubleshooting
14-30
NX-series EtherNet/IP Unit User's Manual (W627)

Omron NX Series Specifications

General

Programming Languages	Ladder, Structured Text, Function Block Diagram, Sequential Function Chart
Communication Ports	Ethernet, USB, RS-232C, RS-485
Memory Capacity	Varies by model
Program Memory	Varies by model
Data Memory	Varies by model
Operating Temperature	0°C to 55°C
Power Supply	24 VDC
Ethernet Ports	1 or 2 ports (depending on model)
USB Ports	1 or 2 ports (depending on model)
Dimensions	Varies by model
Weight	Varies by model