Panasonic MN101L Series

Chapter 9
16-bit Timer
16-bit Standard IGBT Output (with Variable Duty) IX - 49
 Count timing of Standard IGBT Output (when compare register 1 = "0x0000") (Timer 7)
Figure:9.9.2 Count timing of Standard IGBT Output (When compare register 1 = "0x0000")
The IGBT output is "Low" while the TM7MD1.TM7EN is set to "0" to stop counting.
 Count timing of Standard IGBT Output (when compare register 1 = "0xFFFF") (Timer 7)
Figure:9.9.3 Count timing of Standard IGBT Output (when compare register 1 = "0xFFFF")
..
When using the IGBT standard output, set the TM7MD2.TM7BCR to "0" to select the full
count overflow as the binary counter clear source and the IGBT output set source (to "High"
state).
..
..
The TM7OC1 compare match or TM7OC2 compare match can be selected for the IGBT out-
put reset source (to "Low" state) by setting the TM7MD2.T7PWMSL.
..
0000
N+1 N+2 FFFE
FFFF
C
ount
c
lock
T
M7EN
b
it
C
ompare
r
egister
B
inary
c
ounter
0000 00000001 N+1 N-1
N
0000 0001 N-1
N
T
M7IO output
(
IGBT output)
I
GBT
t
rigger
FFFF
N+1 N+2 FFFE
FFFF
C
ount
c
lock
T
M7EN
b
it
C
ompare
r
egister 1
B
inary
c
ounter
0000 00000001 N+1 N-1
N
0000 0001 N-1
N
T
M7IO output
(
IGBT output)
I
GBT
t
rigger