Panasonic MN101L Series

Chapter 10
General-Purpose Time Base/Free-Running Timer
8-bit Free-running Timer X - 9
 Count Timing of Timer Operation (Timer 6)
Binary counter counts up with the selected clock source as a count clock.
Figure:10.3.1 Count Timing of Timer Operation (Timer 6)
1. When any data is written to the compare register during the TM6CLRS = 0, the binary counter is cleared to
0x00.
2. Even if any data is written to the compare register during the TM6CLRS = 1, the binary counter is not cleared.
3. When the binary counter reaches the setting value of the compare register during the TM6CLRS = 1, an inter-
rupt request is set at the next count clock.
4. When an interrupt request is set, the binary counter is cleared to 0x00 and restarts counting.
5. Even if the binary counter reaches the setting value of the compare register during the TM6CLRS = 0, no
interrupt request is set.
M
NM
0001 01 N-1
N02
00 01
Count clock
TM6CLRS
bit
Compare
register
Binary
counter
Interrupt
request
02 03 M-1
M
00 01
1.
3.
4.
2.
5.