Penlon Prima 460 - Page 14

Prma 460 6 User Manual
Warnings and Cautions
leanng and dsnfecton - eneral cautons
1 Reuse of a non-dsnfected breathng system or reusable
accessores may cause cross-contamnaton
2 To prevent leaks, avod damagng any breathng system
components when dsassemblng and reassemblng
Ensure the correct nstallaton of the system, especally
component seals
3. Disconnect the electrical supply before cleaning.
4. Do not allow liquids to run into enclosed areas or on to
electronic components. Serious damage may result.
5 Wear gloves and safety glasses The O sensor contans
a small quantty of electrolyte, classfed as a harmful
rrtant, whch s potentally hazardous
6 leanng and dsnfecton materals
a) Read the cleanng agent data sheet, and the user
manual for all dsnfecton equpment
b) leanng solutons must have a pH of 70 to 105
c) Do not use Cidex or a generic equivalent
d) Do not use organc, halogenated, or petroleum based
solvents
e) Do not use, anaesthetc agents, glass cleaners,
acetone, or other harsh cleanng agents
f) Do not use harsh abrasve cleanng agents (such as
steel wool, slver polsh or cleaner)
7 Do not soak synthetc rubber components for more than
15 mnutes Swellng or faster agng can occur
8 Do not apply excessve pressure to the dsplay screen
9 Pre-use checks must be performed before patent use
after cleanng and dsnfecton
leanng and dsnfecton - Ventlator nternal components
1 The patent block assembly must be removed from the
control unt before sterlsaton
These operatons must be carred out by sutably traned
techncans only
After cleanng and sterlsaton, the patent block
assembly must be reftted to the orgnal control unt
2 For ventlator components whch requre sterlsaton,
peak sterlsaton temperatures should not exceed 134
o

(275
o
F) to prevent possble damage
3 are must be taken not to let any lqud run nto the
control unt serous damage may result
leanng and dsnfecton - Absorber
1 Do not sterlse (autoclave) the manometer
2 Do not allow any lqud to run nto the heater pad area
Do not autoclave the heater pad
3 Autoclavng the absorber canster
a) Dscard the absorbent and dran the condensate from
the canster, then reft the canster to the absorber
assembly, before autoclavng
b) Autoclave temperatures peak sterlsaton
temperatures should not exceed 121
o
 (253
o
F) to
prevent possble damage Maxmum temperatures for
ndvdual components are lsted n ths manual
4 If the absorber has to be lfted or carred by hand, always
support the weght of the unt under the base
Do not lft the absorber by grppng any of the components
attached to the top of the absorber - the manometer,
adustable pressure lmtng (APL) valve, breathng crcut
connectors, etc
leanng and dsnfecton - Masimo Nomoline ISA AX+ and
OR+ Modules (optional)
1 Refer to Appendx 7 for addtonal autons
NOTES
1 Refer to Appendx 4 for general labellng and symbols
2 Refer to Appendx 7 for labellng and symbols for the
optonal Masimo Nomoline ISA Sidestream AX+ and OR+
modules