Adjustment
115
13.24 Sewing motor menu
The sewing motor functions are tested and the needle position is set to t.d.c. in this menu.
Switch the machine on.
Call up input mode.
Call up the sewing motor menu.
Description of the functions
Input mode
This function is used to change the initial status of input mode.
Conclude input
This function is used to conclude the input and the machine switches to sewing mode.
Sewing motor “start”
This function is used to start the sewing motor at the set speed.
Sewing motor "stop"
This function is used to stop the sewing motor again.
Thread trimming
This function is used to perform the thread trimming cycle.
Needle position
The current position of the needle is displayed.
To set the needle bar position to t.d.c., move the needle bar to the corresponding position
by turning the handwheel and accept this position by pressing the “POS” key.
To Next Page
Loading...
