Maintenance and Care
59
These maintenance intervals are based on an average running time of a single
shift operation. Shorter maintenance intervals are recommended for increased
running times.
12.02 Cleaning the entire machine
The required cleaning cycle for the machine depends on the following factors:
Single or multi-shift operation
Dust formation caused by the workpieces
Optimal cleaning instructions can therefore only be defined on a case-by-case basis.
Disconnect the machine from the electricity mains by shutting off the main
switch or removing the mains plug!
Risk of injury due to accidental machine start-up!
Clean the whole machine at least once a week.
Clean the whole machine ......................................................................................... weekly
Clean the needle area ............................................................................ several times a day
Clean the hook area ............................................................................... several times a day
Clean the blower air filter .................................................................................... as required
Clean the maintenance unit air filter (air filter) .................................................... as required
Check the air pressure ......................................................................... daily, before start-up
Check the oil level ................................................................................ daily, before start-up
Lubricate the trimmer .......................................................................... daily, before start-up
Lubricate the stacker drive ................................................................................ twice a year
12 Maintenance and Care
12
.01 Maintenance intervals
To Next Page
Loading...
