Sewing
43
Target state
Infeed table forwards
10.04 Error messages
General
The display will show a error code if a malfunction occurs. An error message is generated by
incorrect handling, malfunctions on the machine or by overload conditions. (For an explana-
tion of the error codes, see chapter 14.02 Explanation of the error messages.)
Error when switching outputs
If an error occurs when switching an output, the relevant output is displayed with the de-
sired switching state (0) or (I).
(0) means that the output should be switched off and (I) means that the output should be
switched on.
The cause of the error is displayed on the next line.
The target state is shown in brackets to achieve an error-free process.
The output S5 should be activated in the following example.
Condition: E4 must be set to (1).
O Check E4 and correct the error.
O Acknowledge the elimination of the error.
Infeed table forwards
Workholder bar up
Target state
Workholder bar up
To Next Page
Loading...
Need help?
General
