Operating Controls
18
Fig. 7 - 05
7.05 Control panel
The current operating statuses are indicated
on the control panel 1. The machine is
operated with constant dialogue between
the control unit and the operator; different
pictograms and / or texts are displayed for
this purpose according to the operating
status of the machine.
Pictograms or texts with a border represent
functions that can be called up by pressing
on the respective point on the monitor.
Pressing the respective function causes
its immediate actuation or activation/
deactivation or another menu will appear,
e.g. for entering a value.
Activated functions are indicated by pictograms shown inversely. Pictograms or texts
without a border are only used for display purposes and cannot be called up by pressing
them.
The SD card 2 in the control panel can be used to import seam programs and operating
software.
Fig. 7 - 06
1
7.06 Pedal
Pressing the pedal 1 switches the
suction air for the infeed table and the
positioning tube on or off.
1
2
To Next Page
Loading...
