Input
46
11.02 Creating / altering seam programs
A distinction is made between three different seam types when creating or altering the
seam programs:
Single-point darts
L3 = L4; program numbers 0 - 199
Double-point darts
L3 < 4.5 mm; is not cut, program numbers 200 - 299
Tapered darts
L3 < L4; program numbers 300 - 399
Fig. 11 - 01
Outer fabric edge
Table edge
L1
CORR
L3
CORR
L4
CORR
Dart length L1
Waist length L2
Dart depth L3
Waist depth L4
Uncut material fold
length L5
Material thickness
Starting stitch
condensation or start
backtack
End stitch condensation
The seam program input is accessed by selecting the desired seam type.
Switch the machine on.
Call up input mode.
Call up seam program input.
To Next Page
Loading...
Need help?
General
