130
Control
14.02.04 Sewing motor errors
Display Description
1 Transmission error
2 Serial interface time-out
3 Checksum error in received data
4 Tme-out command
30h (48) Time-out slave expired (command string incomplete)
31h (49) Incorrect command code
32h (50) Framing or parity error
33h (51) Incorrect checksum
34h (52) Wrong date for queries
35h (53) No parameter can be programmed (motor running)
36h (54) Parameter not available
37h (55) Incorrect parameter value
38h (56) EEPROM is programmed
39h (57) Incorrect machine speed
3Ah (58) Incorrect position
3Bh: (59) Path for guided positioning too low
3Ch: (60) No reset of the position counter possible (motor running)
3Dh: (61) Turning to t.d.c. after power on not permitted
3Eh: (62) SYMA not detected
3Fh: (63) Target position < 3 incr. away from the counting position
40h - 4Fh -
50h: (80) Mains monitor (failure of 2 mains halfwaves)
51h: (81) Power electronics malfunction during initialisation
52h: (82) Short circuit in motor
53h: (83) Mains voltage off detected
54h: (84) Power electronics malfunction during operation
55h: (85) No increments
56h: (86) Motor blocked
57h: (87) Commutation transmitter plug missing
58h: (88) Incremental transmitter plug missing
59h: (89) Faulty motor operation (nominal speed not attained)
5Ah: (90) -
5Bh: (91) Control algorithm locked
5Ch - 69h -
6Ah: (106) EEPROM cannot be programmed
6Bh: (107) EEPROM missing
6Ch: (108) Master reset performed
6Dh: (109) -
6Eh: (110) Residual path for path-controlled, guided delay ramp too short
6Fh: (111) Slave has received 5 garbled messages in succession
70h: (112) Deadman expired
71h - FFh -
To Next Page
Loading...
Need help?
General
