Set-up and Initial Start-up
20
8 Set-up and Initial Start-up
The machine may only be set up and started up by qualified personnel! All of
the relevant safety regulations must always be complied with in this process!
8.01 Set-up
Suitable electrical and compressed air supply connections must be provided at the erection
site, see chapter 3 Technical Data. The erection site must also have a firm and level
subsurface and adequate lighting.
8.01.01 Aligning the machine
Loosen the nuts 1 and turn the feet 2 so that the machine is horizontal.
Tighten the nuts 1.
The alignment on the lower frame tubes can be checked with a spirit level.
Fig. 8 - 01
1
2
To Next Page
Loading...
Need help?
General
