Input
45
Info
This function opens a menu to display the following information:
- Current software status of the machine
- Current firmware status of the machine
- Current firmware status of the control panel
- Daily piece counter
- Bobbin thread monitor stitch counter
- Operating hours counter
- Production hours counter
The daily piece counter and bobbin thread monitor counter can be reset using
the “Clear” function.
Country settings
This functions opens a menu to select the language displayed on the control panel.
Rights of access
This function opens a menu to define the rights of access, see chapter 11.04 Rights of
access.
Stepping motors
This function opens a menu to move the stepping motors.
Sewing motor
This function opens a menu to test and adjust the sewing motor, see chapter 13.24 Sewing
motor menu.
Service menu
This function is used to call up the menu for selecting various service functions, see chapter
13.23 Service menu.
To Next Page
Loading...
Need help?
General
