Planmeca ProMax Technical Manual

Chapter A - GENERAL & TECHNICAL DATA
A-4 Planmeca ProMax
TECHNICAL SPECIFICATIONS
Technical Manual
SmartPan image properties:
Flat panel pixel size 127 m
Flat panel active surface 0.8 x 13 cm (0.31 x 5.1 in.)
Line voltage 100 - 132 V~ / 50- 60 Hz
180 - 240 V~ / 50 Hz
Line current 8 - 15 A
Line harmonics cos better than 0.9
Max. permissible apparent
impedance of supply mains 0.5  (100VAC)
Maximum continuous
heat dissipation < 250W
Electrical classification Class I, type B
Fuses
Weight 119 kg (263 lbs)
137 kg (304 lbs) with Cephalostat
Colour RAL 9016
Environmental requirements
Ambient temperature Pan / ceph X-ray unit:
Operating +5°C to +40°C
Storage ±0°C to +50°C
3D / 3D s X-ray unit:
Operating +10°C to +30°C
Storage ±0°C to +50°C
Humidity 15% - 85%
Original manufacturer
PLANMECA Oy, Asentajankatu 6, FIN-00880 Helsinki, FINLAND
phone: +358 20 7795 500, fax: +358 20 7795 555, www.planmeca.com
REPLACEABLE FUSES
180-240V~ 100-132V~
TYPE
2 pieces (user replaceable) 8A FF 16A FF /500V 195100 ELU

Planmeca ProMax Specifications

General

Category	Medical Equipment
Type	Cone Beam Computed Tomography (CBCT) System
Software	Planmeca Romexis
Imaging Modes	CBCT
Imaging Modalities	2D Panoramic
X-ray Generator	High Frequency Generator
Focal Spot Size	0.5 mm
X-ray Tube Voltage	60-90 kV
Exposure Time	Varies depending on imaging mode and parameters
Dimensions	Varies significantly depending on model and configuration
Weight	Varies significantly depending on model and configuration
Power Requirements	50/60 Hz
Patient Positioning	seated