Planmeca ProMax Technical Manual

Chapter E - C-ARM AND IMAGING ARM
Planmeca ProMax E-103
PROMAX 3D: UPDATING SENSOR SOFTWARE
Technical Manual
12 PROMAX 3D: UPDATING SENSOR SOFTWARE
NOTE The sensor software is updated from an external PC.
a) Start the ProMax3D Tool program.
b) Select Software – Update Sensor Software.
Figure 139
c) Select the software from the browser (e.g. 3D_sensor_2.2.0.0.R.EthUpgrd.ldr).
d) Wait until the software has been loaded successfully, “Sensor Software Updated” message
will be displayed.
e) Select Software – Sensor Software Version to check that the software was updated.

Planmeca ProMax Specifications

General

Category	Medical Equipment
Type	Cone Beam Computed Tomography (CBCT) System
Software	Planmeca Romexis
Imaging Modes	CBCT
Imaging Modalities	2D Panoramic
X-ray Generator	High Frequency Generator
Focal Spot Size	0.5 mm
X-ray Tube Voltage	60-90 kV
Exposure Time	Varies depending on imaging mode and parameters
Dimensions	Varies significantly depending on model and configuration
Weight	Varies significantly depending on model and configuration
Power Requirements	50/60 Hz
Patient Positioning	seated