Planmeca ProMax Technical Manual

Chapter B - INFORMATION DISPLAYS
Planmeca ProMax B-7
USER PREFERENCE SETTINGS
Technical Manual
2.4 Visual adjustments
From the list of User preference settings (i200) select Visual adjustments (i250).
In this mode you can adjust the Dynamic Exposure Control (DEC) settings (i25.1) and
Calibrate the Touch panel (i25.4).
The image taken can be previewed from the Preview Settings (i25.5) after taking the
exposure.
The 3D settings can be adjusted from the 3D display settings (i25.6).
Figure 9
2.4.1 DEC settings
DEC density can be adjusted on the DEC settings display (i251).
Figure 10
DEC density is expressed in percentage in comparison to DEC calibration value. The setting
can be adjusted between 20% (lower exposure values -> brighter image) and 200% (higher
exposure values -> darker image). The recommended setting is 100% (default setting)
NOTE DEC is available for panoramic and cephalometric programs. It is not available for
SmartPan programs (3D V2 / 3D s sensor + SmartPan).

Planmeca ProMax Specifications

General

Category	Medical Equipment
Type	Cone Beam Computed Tomography (CBCT) System
Software	Planmeca Romexis
Imaging Modes	CBCT
Imaging Modalities	2D Panoramic
X-ray Generator	High Frequency Generator
Focal Spot Size	0.5 mm
X-ray Tube Voltage	60-90 kV
Exposure Time	Varies depending on imaging mode and parameters
Dimensions	Varies significantly depending on model and configuration
Weight	Varies significantly depending on model and configuration
Power Requirements	50/60 Hz
Patient Positioning	seated