Planmeca ProMax Technical Manual

Chapter B - INFORMATION DISPLAYS
Planmeca ProMax B-25
SERVICE SETTINGS
Technical Manual
5.1 Special operation mode selection
From the list of Service settings select Special operation mode selection (i510).
Figure 36
5.1.1 Demo licences
The Demo licences option allows you to demonstrate all the ProMax X-ray programs. When
this option is selected no radiation is generated when you press the exposure button. The
programs can be selected and the C-arm will move normally but no radiation will be gener-
ated and no radiation warning signals will be given, i.e. this is a “dummy run” function for train-
ing and demonstration purposes.
5.1.2 Enable high speed ceph
This option allows you to enable the high speed ceph function. This feature enables you to
take an exposure with a higher sensor speed, i.e. the exposure time is shorter.
5.1.3 Enable Bitewing
This option allows you to enable the Bitewing exposure program. You will need a special
licence code for this program. Read detailed instructions given in the user’s manual.

Planmeca ProMax Specifications

General

Category	Medical Equipment
Type	Cone Beam Computed Tomography (CBCT) System
Software	Planmeca Romexis
Imaging Modes	CBCT
Imaging Modalities	2D Panoramic
X-ray Generator	High Frequency Generator
Focal Spot Size	0.5 mm
X-ray Tube Voltage	60-90 kV
Exposure Time	Varies depending on imaging mode and parameters
Dimensions	Varies significantly depending on model and configuration
Weight	Varies significantly depending on model and configuration
Power Requirements	50/60 Hz
Patient Positioning	seated