Planmeca ProMax Technical Manual

Planmeca ProMax H-1
Chapter
Technical manual
H CEPHALOSTAT
1 ADJUSTMENTS AND CALIBRATIONS
NOTE During the adjustments write down the selected parameter values. After the cepha-
lostat adjustment switch the X-ray unit off and on and then check that the new parame-
ter values are stored into the memory.
1.1 Required tools
• Ceph head support alignment tool (part number 00653126).
Figure 1
• Ceph head support alignment laser (part number 10004499). Used to check the position
of the cephalostat head support.
Figure 2
Align_laser.eps

Planmeca ProMax Specifications

General

Category	Medical Equipment
Type	Cone Beam Computed Tomography (CBCT) System
Software	Planmeca Romexis
Imaging Modes	CBCT
Imaging Modalities	2D Panoramic
X-ray Generator	High Frequency Generator
Focal Spot Size	0.5 mm
X-ray Tube Voltage	60-90 kV
Exposure Time	Varies depending on imaging mode and parameters
Dimensions	Varies significantly depending on model and configuration
Weight	Varies significantly depending on model and configuration
Power Requirements	50/60 Hz
Patient Positioning	seated