Planmeca ProMax Technical Manual

Chapter B - INFORMATION DISPLAYS
B-34 Planmeca ProMax
SERVICE SETTINGS
Technical Manual
5.8 Patient support alignment
In the Service settings it is possible to perform a patient support alingment checkup and to do
a fine tuning of the patient support by choosing from the Service settings Patient support
alignment (i580).
NOTE The fine tuning is done after the mechanical adjustment of the patient support.
Figure 51
5.9 Software update
From the list of Service settings select Software Update (i590). In this mode the GUI soft-
ware can be updated.
Figure 52
The update procedure is explained in section 3.1 “GUI software update, only for colour GUI”
on page F-10.

Planmeca ProMax Specifications

General

Category	Medical Equipment
Type	Cone Beam Computed Tomography (CBCT) System
Software	Planmeca Romexis
Imaging Modes	CBCT
Imaging Modalities	2D Panoramic
X-ray Generator	High Frequency Generator
Focal Spot Size	0.5 mm
X-ray Tube Voltage	60-90 kV
Exposure Time	Varies depending on imaging mode and parameters
Dimensions	Varies significantly depending on model and configuration
Weight	Varies significantly depending on model and configuration
Power Requirements	50/60 Hz
Patient Positioning	seated