EasyManuals Logo

Planmeca ProMax Technical Manual

Planmeca ProMax
378 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
Chapter B - INFORMATION DISPLAYS
Planmeca ProMax B-13
FEATURE PROGRAM CONTROL
Technical Manual
3 FEATURE PROGRAM CONTROL
From the list of information displays select Feature program control (i300). In this mode new
features can be added to the X-ray unit.
Figure 17
3.1 Enable / disable features
On the Enable/disable features (i310) display, touch the feature you wish to activate. Enabled
features will be marked with a green check mark. Confirm the selection by touching Done.
By touching the down arrow in the lower left corner more features will appear. On the next
display, touch the up arrow in the lower left corner to return to the previous display.

Table of Contents

Other manuals for Planmeca ProMax

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Planmeca ProMax and is the answer not in the manual?

Planmeca ProMax Specifications

General IconGeneral
CategoryMedical Equipment
TypeCone Beam Computed Tomography (CBCT) System
SoftwarePlanmeca Romexis
Imaging ModesCBCT
Imaging Modalities2D Panoramic
X-ray GeneratorHigh Frequency Generator
Focal Spot Size0.5 mm
X-ray Tube Voltage60-90 kV
Exposure TimeVaries depending on imaging mode and parameters
DimensionsVaries significantly depending on model and configuration
WeightVaries significantly depending on model and configuration
Power Requirements50/60 Hz
Patient Positioningseated

Related product manuals