Planmeca ProMax Technical Manual

Chapter B - INFORMATION DISPLAYS
Planmeca ProMax B-3
USER PREFERENCE SETTINGS
Technical Manual
2 USER PREFERENCE SETTINGS
From the list of Information displays select User preference settings (i200). In this mode you
can set the date and time, perform visual adjustments and select the unit’s behavioural pref-
erences and language.
Figure 2
2.1 Setting date and time
The clock is set at the factory to local time and it should be set to show the correct time/date
before using the unit.
To set time select Set time on the Date & time display (i210). If you want to change date,
select Set date. If you want to change the time and date display format, select Time & Date
display format.
Figure 3

Planmeca ProMax Specifications

General

Category	Medical Equipment
Type	Cone Beam Computed Tomography (CBCT) System
Software	Planmeca Romexis
Imaging Modes	CBCT
Imaging Modalities	2D Panoramic
X-ray Generator	High Frequency Generator
Focal Spot Size	0.5 mm
X-ray Tube Voltage	60-90 kV
Exposure Time	Varies depending on imaging mode and parameters
Dimensions	Varies significantly depending on model and configuration
Weight	Varies significantly depending on model and configuration
Power Requirements	50/60 Hz
Patient Positioning	seated