3
3.61
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
26. Use the Cam Gear Alignment Tool (PU-45497-2) to
align the teeth of the cam gear (M). Install the cam
gear (M) (with the Cam Gear Alignment Tool still in
place) onto the camshaft. The timing marks on the
camshaft gear should align with the keyway on the
balance shaft gear.
NOTE: If the timing mark on the camshaft gear
does not align properly, remove the camshaft
gear and tool. Use the Cam Spanner Wrench (PU-
45498) to rotate the cam to the proper position.
NOTE: Cam Spanner Wrench (PU-45498) is only
needed to rotate the camshaft when the entire
valve train is assembled.
27. Reinstall the camshaft gear so the timing marks are
properly aligned. Install the washer and bolt. Torque
to specification.
NOTE: Be sure all timing marks are aligned.
Counterbalance Gear and Camshaft Gear Bolt:
22 ± 2 ft-lbs (30 ± 3 Nm)
ENGINE
To Next Page
Loading...
