Polaris RZR 800 2013 User Manual

2
2.27
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
6. Torque the wheel nuts and/or hub nut to the proper
torque specification listed in the torque table at the
beginning of this section.
7. If hub nut was removed, install a new cotter pin after
the hub nut has been tightened.
CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear. On vehicles with tapered rear
wheel nuts, make sure tapered end of nut goes into
taper on wheel.
Tire Inspection
• Improper tire inflation may affect vehicle
maneuverability.
• When replacing a tire always use original
equipment size and type.
• The use of non-standard size or type tires may
affect vehicle handling.
WARNING
Operating with worn tires will increase the possibility of
the vehicle skidding easily with possible loss of control.
Worn tires can cause an accident.
Always replace tires when the tread depth measures 1/
8", (3 mm) or less.
Tire Tread Depth
Replace tires when tread depth is worn to 1/8" (3 mm) or
less.
Tire Pressure
Remove the valve stem cap and check tire pressure
using the tire pressure gauge included in the vehicle’s
tool kit.
CAUTION
Maintain proper tire pressure.
Refer to the warning tire pressure decal applied to the
vehicle.
RZR / RZR S
Tire Pressure Inspection (Cold)
Front Rear
8 psi (55 kPa) 8 psi (55 kPa)
RZR 4
Tire Pressure Inspection (Cold)
Front Rear
10 psi (69 kPa) 12 psi (83 kPa)
MAINTENANCE

Polaris RZR 800 2013 Specifications

General

Brand	Polaris
Model	RZR 800 2013
Category	Offroad Vehicle
Language	English