8.8
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
16. Remove the intermediate shaft seal using a seal
puller or other suitable method.
Transfer Case Reassembly
IMPORTANT: Transfer case tapered bearing preload
must be checked and/or adjusted for proper
transmission operation.
1. Install the intermediate shaft seal (circled) flush or
slightly below the case. Install circlips and gear onto
the input intermediate shaft as shown.
2. Install the front output pinion shaft assembly.
NOTE: Bearing is pressed onto the shaft
3. Install the shims, bearing cup and alignment dowels
into the retaining bracket.
TRANSMISSION
To Next Page
Loading...
