2
2.15
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
ENGINE
Engine Oil Level
The twin cylinder engine is a wet-sump engine, meaning
the oil is contained in the bottom of the crankcase. To
check the oil level follow the procedure listed below:
1. Position vehicle on a level surface.
2. Place the transmission in Park (P).
3. Stop the engine and allow it to cool down before
removing the dipstick.
IMPORTANT: Do not run the machine and then
check the dipstick.
4. Locate the engine oil dipstick:
• RZR / RZR S: Remove both seats and the rear
service panel to access the dipstick.
• RZR 4: Remove the right rear passenger seat to
access the dipstick.
5. Lift the lever lock, remove dipstick and wipe dry with
a clean cloth.
6. Reinstall the dipstick completely, but do not lock it.
NOTE: Make certain the dipstick is inserted all
the way into the filler tube to keep the angle and
depth of dipstick consistent.
7. Remove dipstick and check to see that the oil level is
in the SAFE range. Add oil as indicated by the level
on the dipstick. Do not overfill (see NOTE below).
NOTE: Due to the dipstick entry angle into the
crankcase, the oil level will read higher on the
bottom side of the dipstick. Proper level
indication is determined on the upper surface of
the dipstick as it is being removed, regardless of
the level marks being on top or on bottom (see
the next illustration).
NOTE: A rising oil level between checks in cool
weather driving can indicate contaminants such
as gas or moisture collecting in the crankcase. If
the oil level is over the full mark, change the oil
immediately.
8. Reinstall the dipstick and lock the lever.
MAINTENANCE
To Next Page
Loading...
Need help?
General
