5
5.77
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
8. Using a 1" open-end wrench or adjustable wrench,
loosen and remove the bearing cap from the shock
body.
9. Slowly lift up and remove the shock rod assembly
from the shock body.
10. Remove and properly dispose of the oil from the
shock body.
NOTE: Insert the IFP Tool (PS-45908) and cycle
the Internal Floating Piston (IFP) a few times to
purge the shock oil from the reservoir.
11. Remove the floating piston from the shock reservoir
using the IFP Tool (PS-45908).
12. Clean and inspect ALL parts and replace as needed.
IMPORTANT: Seal kits are available and should
be installed at this time if seals or O-rings are
damaged or worn.
13. Use the appropriate shock rod holding tool and a
vise to mount the shock rod vertically with the
threaded end upward.
Shock Rod Holding Tool: 2872429
BODY / STEERING / SUSPENSION
To Next Page
Loading...
