8
8.21
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
12. With the transmission in neutral, lubricate and install
thrust washer, drum gear, plate, springs, contact pins
and gear position sensor/O-ring assembly. Verify the
contact pins are aligned as shown with transmission
in neutral. Torque retaining screws to specification.
Apply Lubricant to shift drum components.
Gear Position Sensor Screws:
25-40 in-lbs (3-5 Nm)
13. Complete the shift detent screw installation. Torque
the outer detent screws to specification.
Outer Detent Screws:
23-27 ft-lbs (31-37 Nm)
14. Install reverse idler lower washer, needle bearing,
gear, upper washer and retaining ring onto idler
shaft.
15. Install a new shaft bearing (if required).
TRANSMISSION
To Next Page
Loading...
