3.24
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
34. Disconnect the cam phase sensor connector.
35. Remove the castle nuts from both rear wheel hubs.
36. Remove the through-bolt that attaches the upper A-
arm to the rear hub on both sides of the vehicle.
37. Pivot the A-arms upward and rear hub carriers
downward and remove the drive shafts from the hub
carriers.
38. Grasp the rear drive shafts and pull sharply outward
on the shafts to disengage them from the rear
gearcase.
NOTE: Clean area around drive shaft orifices on
both sides of rear gearcase and cover orifices
using duct tape. This will prevent the lubricant
from leaking out during removal.
ENGINE
To Next Page
Loading...
