Page 14-10 LTV
®
Series ventilator Operator’s Manual
p/n 10664, Rev. Y
Replacing the Automobile Adapter Fuse
To replace the fuse:
1) Unscrew the knurled nut.
2) Remove the contact point, nut, fuse and spring as shown below. Be careful not to lose the
internal spring, as the adapter will not operate correctly without it.
3) Replace the spring and new fuse as shown.
4) Ensure that the retaining ring is properly in place.
5) Replace the contact point and tighten the nut.
The Universal Power Supply (UPS)
The Pulmonetic Systems Universal Power Supply kit is a rechargeable external power source and
backup system for Pulmonetic Systems’ devices. It has the following features:
• AC/DC Converter
• Backup Battery Charger
• Power and charge status LED
• Audible and visual alarms to indicate loss of mains power
The Universal Power supply provides an AC derived DC power source which is backed up by a
rechargeable 12 volt sealed lead - acid battery. It can power the ventilator and the graphics monitor.
For more information refer to the UPS Operator’s Manual P/N 14492
The Transport Battery System (TBS)
The TBS is a portable, re-chargeable external power source for the LTV® ventilator series. It has the
following features:
• Two no-maintenance re-chargeable Lithium Ion batteries providing up to six hours of mobile
power for the LTV
®
ventilator.
• The TBS is easy and convenient to set-up and operate and the system includes a battery
charger for use when the TBS has been disconnected from the ventilator
For more information about the TBS, see the Transport Battery System Operator’s Manual P/N
17216-001.
To Next Page
Loading...
