Pulmonetic Systems LTV 950 - Event Codes; Event Codes by Code

Operator’s Manual LTV
®
Series ventilator Page E-3
p/n 10664, Rev. Y
Event Codes
This section includes a list of the event codes that can be recorded in the Event Trace.
Event Codes by Code #
Code Event Name Event Associated Alarm
01 VENT 1 Power on None
02 VENT 0 Power off None
03 HOUR MTR Set hour meter None
04 VENT CHK Set vent check Entered VENT CHECK mode
05 APNEA 1 Apnea mode entered APNEA
06 APNEA 0 Apnea mode exited APNEA
07 N/A
08 HIGH DIS High side disconnect DISC/SENSE
09 LOW DIS Low side disconnect DISC/SENSE
10 DISC 0 Circuit disconnect exited DISC/SENSE
11 BATMPT1 Internal battery empty occurred BAT EMPTY
12 BATMPT0 Internal battery empty exited BAT EMPTY
13 BATLOW1 Internal battery low occurred BAT LOW
14 BATLOW0 Internal battery low exited BAT LOW
15 EXT LST1 External power lost occurred POWER LOST
16 EXT LST0 External power lost exited POWER LOST
17 EXT LOW1 External power low occurred POWER LOW
18 EXT LOW0 External power low exited POWER LOW
19 XDC FLT1 XDCR fault occurred XDCR FAULT
20 XDC FLT0 XDCR fault exited XDCR FAULT
21 O2 LOW 1 O
2
pressure low occurred LOW O2 PRES
22 O2 LOW 0 O
2
pressure low exited LOW O2 PRES
23 O2 HI 1 O
2
pressure high occurred HIGH O2 PRES
24 O2 HI 0 O
2
pressure high exited HIGH O2 PRES
25 DEFAULTS Defaults, or Set Defaults occurred DEFAULTS / DEFAULTS SET
26 NO CAL No calibration data found NO CAL DATA
27 FAN FLT1 Fan fault occurred HW FAULT
28 FAN FLT0 Fan fault exited HW FAULT
29 N/A
30 N/A
31 INTRRPT1 Spurious interrupt occurred ms RESET 1
32 INTRRPT2 Spurious interrupt occurred ls RESET 1
33 AD MMTCH ADC mismatch HW FAULT
34 AD MTCH1 ADC mismatch occurred HW FAULT
35 AD MTCH0 ADC mismatch cleared HW FAULT
36 SYNCER1 Stepper motor lost sync occurred HW FAULT