RadioLink Electronic Limited
www.radiolink.com
occupied or not in the “Channel setting” menu. If occupied, please change another channel.
Brake return: Sets the rate that the trigger operation corresponds to the servo returns to
position when brake release. When set to 0%, the A.B.S function is not performed. When set to
50%, the servo returns 50% (1/2) of the trigger operation amount and when set to 100%, the
servo returns to the neutral position.
Delay: Sets the delay from brake operation to A.B.S operation.
When set to 0%, the A.B.S function is activated without any delay.
At 50%, the A.B.S function is activated after a delay of
approximately 0.7 seconds and at 100%, the A.B.S function is
activated after a delay of approximately 1.4 seconds.
Cycle speed: Sets the pulse speed. The smaller the value set,
the faster the pulse cycle. The initial value is 10, 0 to 30 can be
selected.
Interval rate: Sets the proportion of the time the brakes are
applied and the time the brakes are released by pulse operation.
The initial value is 0, -9 to 9 can be selected.
ST trigger to start: steering wheel will trigger the A.B.S function when:
① the Steering trigger function is turned on: the button at the right of “Steering trigger” is ON,
and the background color of the select box is blue.
② the vehicle is performing a braking operation while operating steering
③ the steering amount is greater than the value of the "ST trigger to start"
To Next Page
Loading...
