RadioLink RC8X - Install the Wheel Installation Port Cover

RadioLink Electronic Limited
www.radiolink.com
142
3
Align the steering wheel installation screw mounting position and the screw mounting
position of RC8X.
4
Tighten the two screws.
2.10.4 Install the Wheel Installation Port Cover
1
Insert the 11pin plug on the plate into the corresponding port of the PCB motherboard
on the right side of the RC8X.
2
Gently insert the extra part of the wire into the interlayer of the RC8X PCB board.
3
Insert the black plastic steering mounting plate into the corresponding wheel
installation port.
4
Cover the black plastic USB port plate, tighten the two screws.