RadioLink Electronic Limited
www.radiolink.com
2.11 Wheel or Trigger Mechanical Adjustment
The wheel or trigger of RC8X can be adjusted mechanically according to your needs.
2.11.1 Trigger brake lever adjustment
Make this adjustment when you want to decrease the stroke of the brake side of the throttle
trigger for operation feel.
Adjustment steps:
Using a 1.5mm hex wrench, loosen the trigger tension screw (1.5mm) by turning it slightly
counterclockwise.
Note: Adjust the stroke while observing the screw. Once the mechanical stroke of the
throttle is changed, please re-calibrate the throttle trigger. The calibration method refers to
2.1.10 "Calibration". Due to this change, it is also necessary to adjust the throttle rudder in most
cases The stroke of the machine can be set through "EPA".
To Next Page
Loading...
