RadioLink RC8X - Receiver Introduction and Setup

RadioLink Electronic Limited
www.radiolink.com
18
1.3 Receiver Introduction
1.3.1 Features of R8FG
RC8X, packed with a R8FG, 2.4GHz 8 channels receiver, gyro integrated and high voltage
servo supported.
FHSS spread spectrum algorithm and 67-channel pseudo-random frequency hopping make
the R8FG get excellent anti-interference performance, perfect for multiplayer complete
synchronously.
R8FG also support PWM, SBUS, PPM signals output.
R8FG is default turn off the gyro function (Green LED), if need to turn on the gyro function,
please follow the setting steps: 1.3.4 Signal Mode and Gyro Function of R8FG
1.3.2 Binding
RC8X and R8FG have finished binding by default. So it’s unnecessary to rebind when you
received the new RC8X. Turn on the RC8X and the R8FG, the signal tower will show on the top of
the screen as the picture below, it means the transmitter and receiver have get ready to connect
the ESC, servo, motor, and other equipment that you are prepared for your car or boat.
But if you buy a new R8FG or another receiver for your RC8X, rebind is necessary.
Make sure the transmitter and the receiver have bind success before you are going to
operate the transmitter, each receiver has an individual ID code and must bind with transmitter
before using. When the binding is done, the ID code will be stored in the transmitter and
there’s no need to rebind.