RadioLink Electronic Limited
www.radiolink.com
should check if the PS1 have been set to control other function in the “Channel setting” menu
first, if not, then back to the “Timer” menu to select the PS1 as the timer start switch, if have
occupied, select another switch to instead of the PS1 or select another switch as the timer start
switch.
Reset: the reset switch is set for pause timing and reset timer time. If the timer has started,
press the reset button once to pause the timer, press the timer again to reset the timer time, that
is, to return to 00:00.00.
Vibrator：
“NULL”: indicate that the vibrate function is not enabled.
Type1: the transmitter will vibrate about 1 second at the end of the timer.
Type 2: If the timer function is turned on, the transmitter will vibrate every second. And, the
transmitter will vibrate about 1 second at the end of the timer.
Throttle trigger: the function is defaults turn off.
The button at the bottom of the screen is OFF, and the background color of the select box is
grey, indicating that no matter pulls or push the trigger will not turn on the timer function.
The button at the bottom of the screen is ON, and the background color of the select box is
blue, indicating that when pulls or push the trigger will turn on the timer function.
Attention: If the timer start function selects the trigger as the trigger button and the throttle
trigger function has turned on, the throttle trigger function will be used first.
2.2.5 Lap list
Call lap list when checking the lap memory data (each lap time) memorized by lap timer
To Next Page
Loading...
Need help?
General
