RadioLink Electronic Limited
www.radiolink.com
automatically. The initial value of the Preset point is 0%, 0% to 100% can be selected. The throttle
trigger the Preset point requires:
① The throttle start function is turned on (the Mode switch is ON)
② The throttle rudder amount reaches the value of the “Trigger point”.
③ The Status is “Ready”.
Status: indicates the current throttle start status, “OFF” and “Ready” can be selected,
controlled by the switch that set in “Switch select”. In the “Ready” state, if the throttle trigger
is operated to the position of the “Trigger point”, the throttle servo will accelerate to the set
speed automatically. It is canceled when the throttle trigger is returned.
Setting steps: turn on the RC8X, into home page, click the button at the left bottom of
RC8X into System menu, click into Racing curve menu, click the blue select box named
Start into the menu to set it. Click “-“ to decrease the value and click “+” to increase the
value.
Reset: click Reset will make the value back to the default number.
Back: click the button or short press the power button to return to the previous menu.
2.5.9 Engine cut
When pressing the Engine cut function switch, the throttle servo will move to the presets
position without regard to the throttle trigger position. This is convenient when used to cut the
engine of cars, boats, etc.
To Next Page
Loading...
Need help?
General
