RadioLink Electronic Limited
www.radiolink.com
can change to the ID_1 boat (or any other subsidiary ID boat preferred) and control it
independently to rescue ID_0 boat instead of controlling both boats at the same time, which
makes the rescue more difficult. Unlike traditional binding mode, independent ID can easily
realize rescuing stalled boat in the water caused by various reasons.
Child ID mode setting steps:
1. Tap the button at the right of the “Child ID mode” to change it from “OFF” to “ON”.
Set the ID number according to your cars or boats and then finish the bind and parameters
set for each receiver.
2. Once finished the Child ID mode setting, the corresponding ID number will be displayed
on the main interface of RC8X. (For example: ID_1)
Change the ID number by click “-“ or “+”, click Reset will make the ID number back to
ID_0.
Back: click the button or short press the power button to return to the previous menu.
2.3.3 Servo view
Servo operation of channel 1 to channel 8 can be check in this menu.
The servo operations of each channel, such as the steering wheel or the throttle trigger, can
be confirmed through the graph moves on this menu.
The servo view menu can display the real-time status of each channel in a bar and a
numerical value. You can judge whether the output of each channel is abnormal, especially when
the programmable mixing function is set.
To Next Page
Loading...
Need help?
General
