RadioLink Electronic Limited
www.radiolink.com
or not in the “Channel setting” menu.
Broadcast interval: the interval period for broadcast, if the sensor status and time broadcast
automatically function has turned on, it defaults alarm once every 1 minute, the alarm interval
time can be customized.
Setting steps: turn on the RC8X, into home page, click the button at the left bottom of
RC8X into System menu, click into Telemetry menu, click the blue select box named Voice
to enter the setting page.
Back: click the button or short press the power button to return to the previous menu.
2.5 Racing curve
2.5.1 Steering curve
This function is used to change the sensitivity of the steering servo around the neutral
position. It has no effect on the maximum servo travel. Also, the "Fine tune" function is which can
adjust the rate for left and right separately.
Setting steps: turn on the RC8X, into home page, click the button at the left bottom of
RC8X into System menu, click into Racing curve menu, click the blue select box named
Steering curve into the menu to set the steering curve type, EXP rate etc.
Type: EXP (Steering Exponential) and VTR can be selected, it defaults the EXP type.
If the curve type selects EXP, the steering operates will change with a curved curve from the
neutral point to the endpoint. While if the curve type selects VTR, the steering operates will
change with a linear curve from the neutral point to the high point.
To Next Page
Loading...
Need help?
General
