RadioLink Electronic Limited
www.radiolink.com
2.7 Model select
200 models’ data can be saved in the transmitter RC8X. The name of every model can be
renamed, and the factory settings of every model can be reset in this menu. Data can be copied
and pasted between every two models. Click the model that needs to be set, and the following
settings will appear on the screen:
Model select: model memory selection. You can choose from 7 models on 1 page and 100
models on 15 pages. Tap the mark “Previous” or “Next” at the bottom of screen to switch the
page. When you click the button “Model select”, a question “Are you sure to select the model:
model_1?” will pop out, click “Confirm” to select the model_1 as the current model, the
model’s name can be renamed. If you do not want to select the model_1, click “Cancel” and
then choose the model’s name you want.
The model’s name which you have selected will display on the top of the screen.
Copy model/Paste model: The contents of the model memory can be copied to another
model memory. The copy model function and paste model function must be used as the same
time to finished the model memory copy. For example, if you want copy the model_1 data to the
model_3, you need to click the button “model_1”, click “Copy model”, click “Confirm”
when the question “Are you sure to copy the model? model_1” have pop out, and then click
the button “model_3”, click “Paste model”, click “Confirm” when the question “Copy
model_1 to model_3?” have pop out.
Rename: all the models’ name can be renamed. For example, if you want to rename the
model_1, you need to click the button “model_1”, click “Rename”, a keyboard will pop out,
click “Delete” to delete the original name, tap “←” or “→” to move the cursor and select
To Next Page
Loading...
Need help?
General
