SP Mode Tables
1003
[Paper Buckle]
This SP eliminates the amount of buckle at the registration roller.
When paper is fed from the paper cassette, before the registration
rollers start to rotate the leading edge of the paper stops and hits the
nip of the registration rollers and stops.
The registration rollers remain idle long enough to stop the paper from
skewing in the paper path.
This SP adjusts the amount of time that the registration rollers remain
idle to reduce paper buckle.
Raise this setting to lengthen the amount of time that the paper pauses
at the nip of the registration rollers if you notice a large amount of skew
in printouts.
1-003-011 By-pass: Plain E*
[-5 to 5 / 0 / 1 mm/step]
1-003-012 By-pass: Thick E*
1-003-013 By-pass: Envelope E*
1-003-021 Tray1: Plain E*
1-003-022 Tray1: Thick E*
1-003-023 Tray1: Envelope E*
1-003-031 Tray2: Plain E*
[-5 to 5 / 0 / 1 mm/step]
1-003-032 Tray2: Thick E*
1-003-041 Tray3: Plain E*
1-003-042 Tray3: Thick E*
1-003-061 Duplex: Plain E*
1-003-062 Duplex: Thick E*
To Next Page
Loading...
