Ricoh M160 - Page 738

Bit Switches - 3
SM 82 M160/M161 Fax Option
Communication Switch 02 (SP No. 1-104-003)
No Function Comments
3
Hang-up decision when a
negative code (RTN or PIN) is
received during G3 immediate
transmission
0: No hang-up, 1: Hang-up
0: The next page will be sent even if RTN or
PIN is received.
1: The machine will send DCN and hang up if it
receives RTN or PIN.
This bit is ignored for memory transmissions or
if ECM is being used.
4-5 Not used Do not change these settings.
7 Not used Do not change this setting.
Communication Switch 03 (SP No. 1-104-004)
No Function Comments
0-7
Maximum number of page
retransmissions in a G3
memory transmission
00 - FF (Hex) times.
This setting is not used if ECM is switched on.
Default setting - 03(H)
Communication Switch 04 (SP No. 1-104-005)
No Function Comments
0
Remote mode switch (TEL
mode)
0: Disable
1: Enable (Active)
Set this bit to ON when you wish to switch TEL
mode to FAX mode remotely.
1
Remote mode switch (FAX
mode)
0: Disable
1: Enable (Active)
Set this bit to ON when you wish to turn on the
remote mode switch after automatic reception
with FAX mode.
2
Remote mode switch (AUTO
mode)
0: Disable
1: Enable (Active)
Set this bit to ON when you wish to turn on the
remote mode switch after automatic reception
with AUTO mode.