Rockwell Automation Publication 450L-UM001D-EN-P - December 2019 131
Connected Components Workbench Software Chapter 9
3. Start a new project three ways:
• Click New… under the “Project” heading.
• Click File in the main menu, then click New.
• Press Ctrl-N on your keyboard.
Figure 86 - New Project
Figure 87 shows the New Project window. The Connected Components
Workbench software maintains a list of projects to help prevent you from
overwriting an existing project. The name of each new project increments
by one (for example, Project90). This window allows you to customize the
name and browse for a location for the file.
4. Type a new name, for example, “My 450L Project.”
5. Click Create.
Figure 87 - Project Name
Figure 88 on page 132 shows the Add Device window.
To Next Page
Loading...