Roland VS-2400CD - Page 307

23—MIDI and Synchronization
Roland VS-2400CD Owner’s Manual www.RolandUS.com 307
V-LINK function chart
When V-LINK mode is on (V-LINK lit), the VS-2400CD can control the following functions
on your video device.
*1 For details on the procedure for automix micro editing, refer to “Micro-Editing Automix Data” on Page 328.
For the procedure of playing an automix, refer to “Playing Back Automix Data” on Page 322.
*2 Operations of faders 1–5 can be recorded in the automix. When you play back the recorded automix, the sound
and the image adjustments will occur in synchronization. For details on automix procedure, refer to
“25—Automix” on Page 315.
*2 By holding down CLEAR and pressing CH EDIT for the corresponding fader, you can initialize that parameter
to the center value.
Function Explanation VS-2400CD operation
Select a clip bank Selects one of the 128 clip
banks.
* The number of available clip banks
will depend on the connected video
device.
Use the automix Micro Edit
function to create events.
When you play back the
recorded automix, the clip
bank will be switched.
*1
Select a clip Selects one of the 128 clips
within a bank.
* The number of available clips will
depend on the connected video de-
vice.
Use the automix Micro Edit
function to create events.
When you play back the
recorded automix, the clip will
be switched.
*1
Color difference signal
(Cr) level adjustment
Adjusts the red hues. Turn V.FADER on (lit), and
operate fader 1.
*2
Color difference signal
(Cb) level adjustment
Adjusts the blue hues. Turn V.FADER on (lit), and
operate fader 2.
*2
Dissolve time Specifies the time over which
dissolve (overlap) will occur
when switching between clips.
Turn V.FADER on (lit), and
operate fader 3.
*2
Image brightness
adjustment
Adjusts the brightness of the
image.
Turn V.FADER on (lit), and
operate fader 4.
*2
Playback speed setting Adjusts the video playback
speed.
Turn V.FADER on (lit), and
operate fader 5.
The range of change will
depend on the speed range
setting of your video device.
*2
If you hold down CLEAR and press V-LINK, the parameters of the connected video
device will be initialized. For details on the initial value of each parameter, refer to the
owner’s manual for your video device.
For details on the MIDI messages transmitted in V-LINK mode, refer to “MIDI
Implementation” (Appendices, Page 142).
VS2400OMUS.book 307 ページ ２００６年２月２８日 火曜日 午前１１時１２分