Ruijie RG-WLAN Series

Configuration Guide Configuring Web Authentication
Configuration
Description and Command
popup popup-mode [login-popup |
online-popup]
Configures the way an advertisement
pops up.
Specifying the Advertisement
Mode
(Optional) It is used to specify the iPortal Webauth advertisement mode in template
configuration mode.
popup-mode [login-popup |
online-popup]
Specifies the iPortal Webauth
advertisement mode.
Configuring the Format of the
Webauth URL
(Optional) It is used to configure the redirection URL format for a template.
fmt custom
Configures the format of the Webauth
URL.
Configuring the Redirection
HTTP Port
(Optional) It is used to configure the TCP interception port for redirection, so that the
packets on the specified port can be redirected when interception is enabled.
http redirect port { port-num }
Configures the redirection TCP port.
Configuring Rate Limit Webauth
Logging
(Optional) It is used to configure the syslog function in Web authentication.
web-auth logging enable {num }
Configures the rate limit Webauth logging.
Configuring the Maximum
Number of HTTP Sessions for
Unauthenticated Clients
(Optional) It is used to adjust the HTTP session limit. The limit value needs to be
increased when there are many sessions in the background.
http redirect session-limit { session-num }
[ port { port-session-num }]
Configures the maximum number of HTTP
sessions for unauthenticated clients.
Configuring the HTTP
Redirection Timeout
(Optional) It is used to modify the timeout period for redirection connections. The
timeout needs to be increased to complete redirection when the network condition is
bad.
http redirect timeout{ seconds }
Configures the HTTP redirection timeout.
Configuring the Straight-Through
ARP Resource Range
(Optional) It is used to permit the ARP of the specified addresses to pass. The
gateway ARP must be permitted to pass when ARP check is enabled.
http redirect direct-arp { ip-address
[ ip-mask ] }
Configures the straight-through ARP
resource.
Configuring an
Authentication-Exempted
Address Range
(Optional) It is used to exempt clients from authentication when accessing the
Internet.
web-auth direct-host { ipv4-address
[ ip-mask ] [ arp ] | ipv6-address |
mac-address} [ port interface-name ]
Configures the range of the IP or MAC
addresses of clients free from
authentication.
Configuring the Interval for
(Optional) It is used to configure the interval for updating online user information.