282 • Appendix SAM4S SPS-300 Series Electronic Cash Register AU
Page Field Value Description
ACTIVATE OPEN DRAWER
ALARM
Y or N Select between Y or N to enable or disable open drawer
alarm. See next option for related settings.
3 SECONDS TO ALLOW
DRAWER OPEN (0 - 99)
30 When Open Drawer Alarm is enabled, enter the number as
the number of seconds before the alarm to go off.
ALLOW POST TENDER
Y or N Select Y to allow re-tendering should a second change
calculation be necessary. Re-enter the tendered amount and
press the CASH key to show the new change computation.
OPEN DRAWER ON POST
TENDER
Y or N If you enable post tendering, select N to not open the cash
drawer after the second tender.
ALLOW MULPTIPLE
RECEIPT
Y or N
Use this to allow multiple receipt printing. In conjunction
with Print Option - Buffer Receipt Issue when Receipt is
On (pg12) sets to Y, multiple receipt can be issued by press
CASH key as many time as you need.
4 CASH DECLARATION REQ
BEFORE REPORTS
Y or N Use to determine if Cash Declaration is compulsory before
any reports is made.
MGR CONTROL TO TEND.
NEGATIVE BALANCE
Y or N Use to determine if Manager Control is compulsory when
Negative Balance Tendering occurs. When selected the
control lock must be in the X position to finalise the
transaction.
MGR CONTROL
TO TEND.
ZERO BALANCE
Y or N Use to determine if Manager Control is compulsory when
Zero Balance Tendering occurs. When selected the control
lock must be in the X position to finalise the transaction.
RESET TRANSACTION #
ON Z REPORT
Y or N Use to determine if the Transaction (Receipt) Number is
reset automatically after a Z Financial Report is made.
5 RESET GRAND TOTAL
AFTER Z REPORT
Y or N Use to determine if the Grand Total on the Financial
Report is reset automatically after a Z Financial Report is
made.
OPEN DRAWER WHEN
REPORTS ARE RUN
Y or N Use to determine if Cash Drawer opens automatically when
a report is running.
OPEN DRAWER DURING
TRAIN MODE
Y or N Use to determine if Cash Drawer opens at the end of
Training Mode transaction.
DECIMAL PLACE (0 - 3)
2
Enter a number between to place the decimal point the
selected number of positions from the right.
6 DATE FORMAT IS 0:MDY
1:DMY 2:YMD
1 Use to determine the Date Format between 0 for
MMDDYY, 1 for DDMMYY, or 2 for YYMMDD date
printing format.
MODIFIER:
0:POP UP AFTER ITEM
1:POP UP AFTER SALE
2:STAYDOWN
0
A MODIFIER key alters the next PLU registered, either by
changing the code number of the PLU so that a different item
is registered, or by adding the modifier descriptor and not
changing the code of the subsequent PLU. If you press a
modifier key, you have the option of the modifier applying
only to the next item (0), having the same modifier apply to
any subsequent item registered in the same transaction (1), or
having the same modifier apply to any subsequent item on
any subsequent transaction (2).
To Next Page
Loading...
