Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
20/94
8.4 Image Command
8.4.1 CF_ BRIGHT Command
Command “CF_BRIGHT_%1” [CR]
%1
“000-063”--------------- Directly specify setting value of Brightness
“UP”--------------------- Increment setting value of Brightness by 1
“DN”--------------------- Decrement setting value of Brightness by 1
Details
Set user controlled value of Brightness (Available only in the normal Power ON
status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.2 CF_CONT Command
Command “CF_CONT_%1” [CR]
%1
“000-063”--------------- Directly specify setting value of Contrast
“UP”--------------------- Increment setting value of Contrast by 1
“DN”--------------------- Decrement setting value of Contrast by 1
Details
Set user controlled value of Contrast (Available only in the normal Power ON
status)
The value set by this command will not be stored in the projector. Therefore, when
the power is turned to ALL OFF status, the value returns to the original setting. (It
is stored in Suspend mode.)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.3 CF_COLOR Command
Command “CF_COLOR_%1” [CR]
%1
“000-063”--------------- Directly specify setting value of Color
“UP”--------------------- Increment setting value of Color by 1
“DN”--------------------- Decrement setting value of Color by 1
Details
Set user controlled value of Color (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.4 CF_TINT Command
Command “CF_TINT_%1” [CR]
%1
“000-063”--------------- Directly specify setting value of Tint
“UP”--------------------- Increment setting value of Tint by 1
“DN”--------------------- Decrement setting value of Tint by 1
Details
Set Tint value (Available only in the normal Power ON status)
The value set by this command will not be saved to the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]

Sanyo PLC-HP7000L Specifications

General

Brand	Sanyo
Model	PLC-HP7000L
Category	Projector
Language	English