Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
26/94
8.5.4 CF_H-POS Command
Command “CF_H-POS_%1” [CR]
%1
“0000-nnnn” -------- Directly specify setting value of Horizontal Position
“nnnn” indicates maximum value, which is current value of (Total dots - Display area H)
“UP” ------------------- Increment setting value of Horizontal Position by 1
“DN” ------------------ Decrement setting value of Horizontal Position by 1
Details
Set value of Horizontal Position in PC signal (Available only in the normal Power
ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable “000” [CR]
Response
Unacceptable
“101” [CR] --- When input is Video signal
--- When input is no signal
8.5.5 CF_V-POS Command
Command “CF_V-POS_%1” [CR]
%1
“0000-nnnn” ------------ Directly specify setting value of Vertical Position
“nnnn” indicates maximum value, which is current (Total Line – Display Area V) value
“UP” --------------------- Increment setting value of Vertical Position by 1
“DN” --------------------- Decrement setting value of Vertical Position by 1
Details
Set Vertical Position value (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable “000” [CR]
Response
Unacceptable
“101” [CR] ---- When input is Video signal
--- When input is no signal
8.5.6 CF_DDOTS Command
Command “CF_DDOTS_%1” [CR]
%1
“0100-nnnn” -------------- Directly specify setting value of Display Dots
“nnnn” indicates maximum value, which is current value of (Total Dots - Position H).
In this projector, the value should be “even number” and if “odd number” is specified, it
adds 1 to make the value even number.
“UP” ------------------------ Increment setting value of Display Dots by 2
“DN” ------------------------ Decrement setting value of Display Dots by 2
Details
Set setting value of Display Dots in PC signal (Available only in the normal
Power ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable “000” [CR]
Response
Unacceptable
“101” [CR] --- When input is Video signal
--- When input is no signal

Sanyo PLC-HP7000L Specifications

General

Brand	Sanyo
Model	PLC-HP7000L
Category	Projector
Language	English