Sanyo PLC-HP7000L - CF_CORNERTESTPAT Command; CF_CEIL Command; CF_REAR Command; CF_SCREENASPECT Command

PLC-HP7000L Expand Serial Command Functional Specifications
38/94
8.7.13 CF_CORNERTESTPAT Command
Command “CF_CORNERTESTPAT_%1”[CR]
%1
“RED” ------------Select Red
“WHITE” -------- Select White
“BLUE” ---------- Select Blue
“OFF” ------------ Select Off
Details
Display test patterns for Corner correction.
(Available in normal Power ON status only)
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF.
Acceptable “000”[CR]
Response
Unacceptable “Error Code”[CR]
8.7.14 CF_CEIL Command
Command “CF_CEIL_%1” [CR]
%1
“ON” --------------------------- Set Ceiling to ON.
“OFF” ------------------------- Set Ceiling to OFF.
Details
Set/Cancel Ceiling mode.(Available only in the normal Power ON status)
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.7.15 CF_REAR Command
Command “CF_REAR_%1” [CR]
%1
“ON” --------------------------- Set Rear to ON.
“OFF” ------------------------- Set Rear to OFF.
Details
Set/Cancel Rear mode (Available only in the normal Power ON status)
When Rear is ON, projected image is left/right reversed.
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.7.16 CF_SCREENASPECT Command
Command “CF_SCREENASPECT_%1”[CR]
%1
“43MODE” ･･･････ Select 4：3 mode
“169MODE” ･･････ Select 16：9 mode
“1610MODE” ･･････ Select 16：10 mode
Details
Set Screen aspect mode.
This command is available in normal Power ON status.
Acceptable “000”[CR]
Response
Unacceptable “Error Code”[CR]